Solid Forged Brass: Entrance handle, cylinder collar, knob, rose, and turn piece are manufactured of solid forged brass for maximum strength and durability. Installation: Images lock sets are designed for easy installation in standard pre-bored wood or metal doors. The adaptor aligns the latch with the trim. Graphic instructions make installation fast. Door Thickness : Lock sets accomodate a door thickness of 1-3/4" to 2". Cannot be installed on doors thicker than 2". Case: Deadbolt and latch case are formed of steel for strength. Most interior parts are made of solid brass or steel for maximum strength and smooth operation. Backset: Adjustable backset 2-3/8" or 2-3/4" latch and deadbolt supplied standard. Faceplate: Deadbolt and latch are supplied with a 1"(25mm) faceplate. Strike: Deadbolt is furnished with a specially designed reinforcing strike constructed of high grade steel for ulimate strength and durability. The strike is installed with two 3" security jamb screws and a dust box. The security strike is covered with an armored front to conceal the fasteners. The 3" screws securing the inside face of the double cylinder deadbolt resist tampering and guard against theft. Latches are supplied standard with a box strike Bolt: Deadbolt and latch bolt are constructed of solid brass. Deadbolt has 1" throw when extended and a hardened steel insert for maximum security and protection. Latch bolt has a .5" throw when extended to fully engage the door jamb. Distance Between Latch and Deadbolt: Lockset accommodates any center-center spacing greater than 4-3/8". Cylinder: Cylinder supplied with 5-pin keying. Cylinder is protected with free turning cylinder guard to resist gripping or twisting. Keying: All keyed entry products are available keyed alike. Door Prep: The two-point locking handleset requires additional door prep. Standard 5-1/2" center to center prep will work with an additional bore hole. Please see Installation Instructions Note: When installing a two-point handleset on a door prepped for a standard single point handleset with a 5-1/2" center-to-center boring, the location of the thumb piece will be approximately 2-1/2" lower. |