Weslock Utica Lever Handle

Weslock Utica Lever Handle Specifications

The Weslock Utica lever has a simple curved design and is available in 4 finishes to coordinate with your other Weslock door hardware. Weslock Utica levers are shipped with square and rounded corner faceplates and strikes. Drive in latch is available upon request.

- Limited Lifetime Mechanical Warranty
- Removable levers prevent scratching during installation
- 5-Pin Cylinder
- Meets ANSI A 156.2 Grade II cylindrical lock standards.
- Locksets have concealed screws, which are covered by a snap-on rosette
- Panic-Proof Keylocks - one turn of interior lever unlocks and opens door
- Adjustable Latches with removable latch faceplate
- 2 3/8" or 2 3/4"
- Fits doors from 1 3/8" - 1 3/4" thick.


Available Finishes


Oil Rubbed Bronze	Satin Nickel

Click here to learn how to determine the handing of your door.

Whats Included in Your Weslock Utica Door Lever

Passage Door Lever Contents
A Lever for both sides of the door, latch mechanism, strike plates and mounting screws.

Privacy Door Lever Contents
A Lever for both sides of the door, latch mechanism, generic unlocking tool, strike plates and mounting screws.

Keyed Entrance Lever Handle Contents
A Lever for both sides of the door, latch mechanism, keys, strike plates and mounting screws. If you have several keyed locks keyed alike, there may not be a key for every lock shipped.

Single Dummy Lever Handles
A single non functioning lever and mounting screws

Weslock Utica Lever Handle Functions

Weslock Lever Handles are available in several functions. Please review the descriptions below so you can order the correct door lever for your application.

	Weslock Passage or Hall and Closet Lever Handles are used on doors that do not require a locking mechanism. Halls, closets, pantry or laundry doors will generally use a passage leverset. Passage levers do not have a locking mechanism.

	Weslock Privacy or Bed and Bath Door Levers are most often used on Bedrooms, Baths or Office doors where a lock for privacy while occupied is desired, but a keyed lock is not really necessary. Weslock privacy levers have a Push button on the rosette or backplate as shown to the left to activate the lock. On the outside, there is a pin hole for emergency unlocking. Some levers will have a pin hole inside a circular piece, some just have a small pinhole.

	Weslock Keyed Entrance Door levers are generally used on exterior doors, but sometimes used on interior doors where security is a concern. Weslock keyed entrance leverss have a push button lock on the inside backplate, similar to a privacy lock. On the outside there is a keyed cylinder. If the Lever is locked from the inside a key is required for entrance. If you are ordering several keyed locks of the same brand we can key them alike for you.

	Weslock Single Dummy Door Levers are sold individually. Dummy levers do not have a latch or mechanism of any kind. These levers are surface mounted to a door that has not been bored (large hole cut out) for a lever. Dummy leverss are generally used on double doors that us a ball catch at the top to keep them closed so a latch is not required. They are also commonly found on the inactive side of a french door - a single dummy mounted on either side of the inactive door.

Weslock door hardware products are covered as long as the original purchaser owns or occupies the premises on which the product was installed. For complete warranty information see Weslock Warranty.

Weslock Utica Lever Handle Measurements